How the figures are measured

What each figure on this site means, and how far to trust it. 119 of the 196 trails have a track whose length was measured and checked against the published length.

Length

A trail’s length here is the end-to-end length of its canonical path: one walk from one end to the other, taking one branch at a split, leaving out side trails and counting no stretch twice. It is the figure the trail’s holder or author gives for that walk, and each record says where it comes from. A trail that cannot be walked from end to end today is not listed. The lists and pages show the length in miles with kilometres after.

Some holders also publish a larger figure for a whole system, or a planned total. A record keeps it apart as the whole system, with what it counts, and no list, length band or time estimate uses it. 2 of the 196 records have one. A trail that can be walked through but is partly unbuilt keeps the holder’s end-to-end route as its length and gives the built length beside it. 3 of the 196 records give one.

Where a track is included, its length is measured along the track as a geodesic length and compared with the published figure. The difference is the measured length minus the published length, as a percent of the published length. Track ends within 100 metres are joined, and the number of parts left is shown.

Across the 119 measured tracks, the middle difference is 3.3 percent.

How the measured tracks compare
Measured against publishedTracksShare
Within 5 percent6857%
5 to 15 percent3429%
More than 15 percent1714%

A track that differs by more than 15 percent needs a reason in its record, such as a trail that is partly unbuilt, a published length that is a planned one, or side trails counted in the figure. 19 of the 119 measured tracks give one. A track that covers only part of a trail is marked as partial, and its measured length is not its trail’s length.

78 records have no track included. Their length is the published figure alone, and nothing has been measured.

Time

The usual time to walk the whole trail in one go, in days, as a source states it. Weeks count 7 days, months 30. 75 of the 196 records have a time a source states. For the others the page estimates it from the length, at 12 to 19 miles (20 to 30 km) a day, or 7 to 12 miles (12 to 20 km) a day where much of the trail is cross-country. An estimate is labelled as one wherever it is shown.

Climb

Climb is the total ascent along the track. It uses Terrain Tiles (Mapzen terrarium), open data on AWS, sampled every 30 metres, with moving average over 90 m of track; ascent and descent counted with a 5 m reversal threshold. Computed from a public elevation model, not measured on the ground. Highest and lowest are the model's values at the sample points, with anything below sea level shown as 0. Ascent and descent depend on the smoothing and the threshold, and published figures for the same trail can differ from them by 15 percent or more. Parts of the track are never joined, so a gap is not counted.

A climb is ranked or shown in a list only where its track covers the whole trail: a track that covers part of the trail, or more than the trail, would mislead.

Season and high point

The months in which the whole trail is usually walked, as a short phrase. Not the dates a park or hut is open, unless those set the walking season. The elevation of the highest point in metres, rounded to the nearest metre (converted from feet where the source gives feet). Not every record has them, so a page built from them says how many records it covers.

What the records have

How many records carry each figure
FigureRecords with itRecords without
A usual time stated by a source75121
A season77119
A high point51145
Terrain16729
What the walking is17224
A computed climb that covers the whole trail10294
A track included here11878

Every fact is read on a page that the record names. See the sources, the record schema and the glossary.